You must only order your turf after you have completed all the groundwork.
Arrange for your lawn turf to arrive no more than 1 day before you hope to
lay it. When it arrives, if it is hot and dry, soak the
outside of the pallet with water, making sure to apply plenty water
to the ends of turf that are showing.
When you order your turf from TurfandStuff, you get the delivery on the
weekday of your choice. You enter the required delivery date at step 4 of the checkout procedure. You can plan this up to 1 month ahead.
How to lay lawn turf:
Step 1:
If required, sprinkle pre-turfing fertiliser evenly over the area. Rake lightly
to incorporate it and give a finished smooth surface. If you have used our rootzone topsoil you can skip this stage
Step 2:
Now lay the turf. You can either lay turf whilst standing
on the raked ground or whilst standing on laid turf with the use
of planks to prevent marking your new lawn. If you stand on the
soil, give each row a light rake to remove your foot marks.
Step 3:
Start from the longest straight edge and roll out a turf. DO NOT
stretch the tuf or you will get shrinkage later. If you are happy
with the angle of your first turf, roll out another one. Push the
starting edge of the second turf right against the first one making
sure to butt all joins up tightly. Do not have lawn turf overlapping
on top of previously laid turf. You can use the the rake to
pull the turf close together.
Step 4:
You do not need to roll the turf at this stage except at
the joins. However if you have a very light roller this
can be used to help the turf to soil contact. Make sure and
manually compress the very start (centre) of the roll of turf (where
the harvesting machine started the turf) As it is always
misshapen.
Step 5:
If you have any gaps created through poor cutting or uneven turf sizes,
you should blend the edges closer together by manually stretching,
almost tearing the edges. (like flattening out dough). The turf
will contract some but you do improve the join. If the gaps
are too big for this, use a sharp knife to cut slivers from your
off cuts of turf and squeeze these into the gap. Remember wherever
you do this type of join, will need extra water to help recovery.
Step 6:
Here's a secret used by turf laying contractors to
increase the "wow" factor on a new lawn.
Roll out your alternate rows of turf in opposite directions. This gives a good
striped "just mown" look. Do not use small cuttings at the edges
of the lawn. Use them in the middle.
Step 7:
It is best to sort your edges last, leave enough lawn turf overlapping
your planned edge, that once you are done, you can lay a hose or
rope around the edge and use an edging iron to shape your turf. This
can be left fairly rough, you can smooth this off easier when the
turf has rooted down in a couple of weeks.
Step 8:
When you are done, unless plenty of rain is
forecast, you must irrigate the grass. If you can't apply water due to
hosepipe bans or water meters, then leave lawn turf laying to the
cooler seasons. This must be a very good watering, it may take
several hours of sprinkler to put on enough. This should be repeated
regularly for 1 month.